General Programme 2025

| * 654

666 - 667

ring wrenches for torque bars, round drive, Ø 22 mm

THE WRENCHES THAT DO NOT REQUIRE RELEASING TENSION AFTER USE RENCHES THAT DO NOT REQUIRE RELEASING ON AFTER USE

LA

L

Even if tension is not released, the number of cycles,durability and tightening accuracy as requiredby reference standards are guaranteed. In order to confirm these parameters, Beta Utensili’s Research & Development Department performed numerous durability tests at the in-house laboratories as at hundreds of end users’. This result has been obtained through: • the use of the best-performing currently available materials; • special heat treatments on interior parts. nsion is not released, the number durability and tightening accuracy edby reference standards nteed. o confirm these parameters, sili’s Research & Development nt performed numerous durability e in-house laboratories as at hundreds ers’. t has been through: of the best-performing currently materials; heat treatments on interior parts.

 mm 22 24

L mm

LA mm

A mm

 

98,5 56 38 98,5 56 38

1 006540022 1 006540024 1 006540027 1 006540030 1 006540032 1 006540034 1 006540036 1 006540041 1 006540046 #

27 102,8 56 46,5 30 102,8 56 46,5 32 106,5 56 55 34 106,5 56 55 36 106,5 56 55 41 115,5 56 72 46 115,5 56 72

659/15 | *

adaptor with rectangular female (14x18 mm) and male (9x12 mm) drives

L

L mm

 mm

 mm

LA mm

The Zero-Reset torque wrench was entirely designed and developed in-house and is manufactured at Beta Utensili’s factories in Italy, using 100% Italian-made parts. 100% MADE IN ITALY Reset torque wrench was entirely desig oped in-house and is manufactured at B factories in Italy,using 100% ade parts. % MADE IN ITALY gned Beta Y

 

* 51 14x18 9x12 32

1 006590815

*Caution! Recalculate torque value to set as shown in table in introductory page of section

Always apply torque loads evenly and progressively to avoid breakage and any possible injury.

#

| * 659/16

The settings of the wrench no longer have to be restored to a minimum level at the end of the cycle of use. ngs of the wrench no longer have tored to a minimum level at the end cle of use. d

adaptor with rectangular female (9x12 mm) and male (14x18 mm) drives

L

3

L mm

 mm

 mm

LA mm

 

* 51 9x12 14x18 31

1 006590816

*Caution! Recalculate torque value to set as shown in table in introductory page of section

2

#

3

1

4

2

4

1

5

6

5

6

65 