General Programme 2023

1498/120A

1498/40A

1498SM-C

electronic multipurpose battery charger, 12V

multipurpose battery charger / starter, 12-24V wheeled

OBD II car memory saver connectors, 12V, for item 1498SM/C

Allows batteries to be charged and powers motor vehicles while reprogramming and self-diagnosing

Since no internal battery is available, thestart function (max. 350A) does not replace that of a specific starter type1498LT/12 (2000A).





 

1498SM-C

1 014980021

1498SM-CP

car memory saver connectors, 12V clamp, for item 1498SM/CP

120A

 

- maximum continuous charging current: 120A - charging and maintenance with CPU microprocessor - battery recovery function - reprogramming and power supply for ECU - protected against polarity reversal, short circuits, incorrect voltage and overload TECHNICAL DATA Power supply: 90-260V Power: 1500W Charging current: 10-120A Battery type: Agm - Wet - Lithium (LifePo4)

1498SM-CP

1 014980022

1498SM-A

• 3 programmed charging cycles and 1 manual cycle • electronic adjusting potentiometer • specific WET-SPIRAL/GEL-AGM charging cycles • electronic control and protection system • 10-stage charging process • battery desulfurization and recovery function • supply function • dual voltage, 12-24V • also suitable for Start&Stop batteries • professional rubber-insulated brass clamps

memory saver power supplies for item 1498SM/A

Charging capacity: 10-1200Ah Maintenance capacity: 5-3600Ah Output voltage: 12 Volt Cable length, with clamps: 2700 mm Dimensions: 310 x 150 x 350 mm Weight: 8.5 kg

TECHNICAL DATA Power supply: 230V Output voltage: 12-24V Charging current: 1-40A Starting current: 350A max cc Charging capacity: 4-450Ah

 

1498/120A

1 014980142

 

 

1498/40A

1 014980140

1498SM-A

1 014980023

330x250x792

1498TB/6-12

​analogue battery tester, 6-12V for testing 6V and 12V batteries up to 1000CCA

1498SM

memory saver, 12 V

prevents data stored by computer on board cars from getting lost during maintenance jobs or battery replacement.



READING TABLE TEST RESULTS: OK (GREEN) Battery capacity is OK. Battery may or may not be fully charged. Make sure it is completely recharged. WEAK or BAD but needle remains in fixed position (YELLOW OR RED): UNSATISFACTORY battery capacity. Battery may be faulty or not completely charged. If battery is not fully charged (100%) battery must be replaced. WEAK or BAD but needle does not remain fixed in place - (YELLOW OR RED): Battery may be faulty or to the ground. Replace battery.

Technical specifications: - self-supplied - internal battery Pb 5 Ah - 12 volts - professional connection with OBD socket

L mm

L1 mm

P mm

 

 

1498TB/6-12 290 170 75

1498SM

1 014980420

1 014980020

200 