Action Baltic 2022

+



1498/12

 014980480

€ 400,00

€ 460,00

Portable car starter, 12V

TECHNICAL DATA: • Pickup current: 2200A • Shoulder strap included • Sealed lead acid battery, solid electrolyte (AGM) type

1498/16A

16A



 014980126

€ 289,00

€ 358,00

​• Backlit graphic display​ • Max. charging current: 16A, continuous • Charging and charge maintenance • Protected against polarity reversal and short circuits • 9 charging steps • Floating system • SHOW ROOM function (13.8V - 12A) • SUPPLY function (14V - 12A) • Memory saving function (13.8V - 12A) • Battery recovery function • Clamp holder • Reclining hook fastening • Supplied accessories: cable with clamp, cable with eyelets ​Electronic multipurpose battery charger, 12-24V

TECHNICAL DATA Power supply: 220-240V Power: 240W Charging current: 4-16A Battery types: Agm - Wet - Lithium (LiFePo4) Charging capacity: 5-360Ah Maintenance capacity: 5-550Ah Output voltage: 12-24V Minimum battery voltage: 0.8V Degree of protection: IP20



1760DGT/2

 017600008

€ 496,00

€ 628,00

​Digital automotive multimeter, portable, with 2-channel oscilloscope and waveform generator

OSCILLOSCOPE SPECIFICATIONS Horizontal Bandwidth: 40MHz Sampling frequency range: 250MSa/s (single channel) - 125MSa/s (double channel) SEC/DIV range: 5ns/div ÷ 500s/div 1,2,5 sequence Vertical VOLTS/DIV range: 10mV/div÷10V/divat BNC input Selectable analogue, bandwidth limit, typical: 20MHz Low frequency response (-3db): ≤10Hz a BNC DC Gain Accuracy: ± 3% for Normal or Medium acquisition mode, 10V/div ÷ 10 mV/div Trigger Type: Edge Mode: Auto, Normal, Single Slope: Rising, Falling, Rising, & Falling Source: CH1, CH2 Input Coupling: DC, AC or GND Supported probe attenuation factors: 1X, 10X, 100X, 1000X Arbitrary waveform generator Waveform frequency: Sine (1Hz÷25MHz), Square (1Hz÷10MHz), Ramp (1Hz÷MHz), EXP (1Hz÷5MHz) Width: 2.5Vpp (50Ω) - 5Vpp (high impedance) Output impedance: 50Ω

KIT CONTENTS: - multimeter tips

- 2 BNC crocodile clips for oscilloscope - tip probe for oscilloscope (1X and 10X) - battery charger - nylon sheath

40 mm

199 mm

98 mm

MULTIMETER SPECIFICATIONS Test: Voltage, Current, Resistance, Capacity, Diodes and On-Off

TECHNICAL DATA Display:

2.8” colour TFT

Resolution: 320 x 240 pixels Power supply: 100V-240V AC, 50Hz-60Hz; DC INPUT 5V DC-2A Battery: 2 x 2600 mAh

Max. voltage: 600V DC Max. current: 10A DC Max. resistance: 40MOHM Max. capacity: 100uF

61